Technical data sheet
MS40201350

Drilling › Reamers › MS402

MS40201350

Solid carbide cylindrical reamer with left-hand spiral and right-hand cutting

Dimensions

d1h7d2h6l10/+1l20/+1Flutes
13.512.5160.047.08

Properties

CoatingNo
Helix angle7°
StandardDIN 212

Cutting parameters

MaterialDescriptionMachinabilityVcm/minfnmm/rev
P.0Long chipping Low Carbon SteelsRecommended15-300.29
P.1Short chipping Low Carbon SteelsRecommended15-300.29
P.2Medium and High Carbon SteelsRecommended15-300.29
P.3Alloy Steels, Tool Steels (N/mm² 600-850)Recommended10-200.264
P.4Alloy Steels, Tool Steels (N/mm² 850-1400)Partially recommended10-150.211
P.5Ferritic, Martensitic, PH SSPartially recommended5-150.198
P.6High Strength Ferritic, Martensitic, PH SSPartially recommended5-150.198
M.1Austenitic Stainless SteelPartially recommended5-100.198
M.2High Strength Austenitic SS, Cast SSPartially recommended5-100.198
M.3Duplex SSPartially recommended5-100.198
K.1Grey Cast IronPartially recommended10-200.264
K.2Low and Medium Strength CGI, Ductile IronsPartially recommended10-200.264
K.3High Strength Ductile and Austempered Ductile IronPartially recommended10-200.264
N.1Wrought AluminiumPartially recommended40-600.396
N.2Low Si Al Alloys and Magnesium Alloys Si<12%Partially recommended40-600.396
N.3High Si Al Alloys Si>12%Partially recommended40-600.396
N.4Copper, Brass, Zinc Based AlloysPartially recommended40-600.396
S.1Iron Based HRSAPartially recommended5-100.158
S.2Co Based HRSAPartially recommended5-100.158
S.3Ni Based HRSAPartially recommended5-100.158
S.4Ti and Ti AlloysPartially recommended5-100.198
H.1Hardened Materials (HRC 44-48)Partially recommended5-100.10533333333333333
H.2Hardened Materials (HRC 48-55)Partially recommended4-80.08666666666666667
O.1Thermoplastic and thermosetting materialsPartially recommended50-700.379