How can medical-grade titanium be drilled without overheating?

In the medical sector, drilling titanium must not only meet dimensional requirements but also guarantee metallurgical integrity: no overheating that alters the microstructure (Alpha-case layer) and no contamination. Special drills are used, often uncoated or with certified biocompatible coatings, at low cutting speeds and high feeds to transfer heat into the chip. Temperature control is vital to avoid surface oxidation.

Which drills should be used for medical-grade titanium?

Medical requirements:

  • Substrate: Ultra-pure carbide.
  • Geometry: Drills with very low cutting force and rake angles above 15°.
  • Coating: Standard TiAlN is often avoided because of potential aluminum release. DLC (where compatible) or uncoated mirror-polished drills are preferred to reduce mechanical friction.

How can overheating and galling be reduced when drilling medical-grade titanium?

“Cool Cut” strategies:

  • Low Vc: 30-45 m/min. It is slow, but helps keep temperature below critical phase-transformation limits.
  • Feed: Aggressive relative to diameter (e.g. 0.05 mm/rev on Ø 1 mm). A thick chip carries away more heat.
  • Pecking Frequency: If necessary (e.g. long cannulated screws), use frequent chip-clearance cycles so hot chips do not accumulate inside.

When should internal coolant be used to drill medical-grade titanium?

Through Spindle Coolant (TSC):

  • Absolutely: It is almost mandatory for holes >3xD.
  • Why: It not only cools; the mechanical action of the jet prevents chips from welding to the cutting edges, which is the #1 cause of sudden temperature increase.
  • Fluid: Vegetable-based or synthetic medical-approved oils are often used at high pressure.