How can consistent accuracy be achieved in microholes?

Repeatability in micro-holes depends on the thermal chain and centering. A common mistake is to neglect Z-axis thermal expansion: on a 3 mm deep blind hole, 0.05 mm of thermal growth changes the functional tolerance. Constant accuracy requires frequent probing cycles and the use of “short and rigid” pilot drills that create a perfect guide, effectively a virtual bushing, for the long drill.

Which micro drill should be selected for microdrilling hard steels?

Microdrill selection:

  • Carbide: Ultra-fine grain (< 0.5 µm) so the cutting edge is geometrically well-defined rather than granular.
  • Geometry: For high accuracy, flat-bottom drills or drills with double-margin guidance provide better cylindricity.

How can micro-drill breakage be avoided during microdrilling?

Avoid breakage and scrap:

  • Coolant Filtration: In micromachining, a dirt particle can block a 0.1 mm coolant channel, causing immediate overheating failure. Filtration to 5 microns is recommended.
  • Power Monitoring: Use spindle-load monitoring systems to detect micro-chipping before catastrophic breakage.

Which parameters improve stability and accuracy in microholes?

Stability parameters:

  • RPM: High but not excessive, to avoid harmonic vibration.
  • Feed: Constant.
  • Strategy: Pilot (1-2xD) -> deep drilling. Never enter the pilot hole at maximum rpm; enter at zero or low rpm, then activate spindle and coolant.