
How can friction be reduced in milling?
Reducing friction in milling means optimizing the interface between the tool and the forming chip (secondary sliding zone) and between the tool and the machined workpiece (tertiary zone). High friction generates excessive heat, quickly leading to crater wear or built-up edge (BUE), which compromises surface finish.
The correct approach combines three elements: surface modification of the tool (coating and lapping/polishing), the use of high-lubricity cutting fluids (or cold air where the coating allows it), and cutting parameters that transfer heat into the chip.
Which tool coatings reduce friction and heat in milling?
Thin-film technology (PVD/CVD) is the first line of defense against friction:
- DLC (Diamond-Like Carbon): Excellent for non-ferrous alloys (aluminum, copper) and plastics. It has a very low coefficient of friction (often < 0.1).
- TiAlN / AlTiN-based Coatings: For steels and cast irons. They form protective oxides at high temperatures that act as a thermal barrier.
- Post-Coating Treatments: Polishing or lapping after coating is essential to smooth the micro-droplets typical of the PVD process.
How should cooling and lubrication be selected to reduce heat in milling?
There is no universal choice; it depends on the material:
- Emulsion (Oil in Water): Excellent when both heat removal and friction reduction are needed. Ideal for stainless steels and superalloys.
- MQL (Minimum Quantity Lubrication): Sprays micro-droplets of oil directly into the cutting zone and drastically reduces sliding friction.
- Dry (with Air): On hardened steels milled with modern coated tools, air removes the chip while avoiding thermal shock.
How can surface finish be improved by reducing friction in milling?
A mirror finish is an indication of low friction and clean cutting. It can be achieved as follows:
- Increase Cutting Speed (Vc): High speed reduces built-up edge formation.
- Use Cutters with Wiper Geometry: A wiper geometry levels the scallops left by the feed.
- Climb Milling: Whenever possible, mill in climb. In conventional milling, the tool slides and rubs before cutting, generating friction.