
How can Ti-6Al-4V be machined more efficiently?
Efficiency on Ti-6Al-4V is not achieved by increasing Vc, which would destroy the tool, but by increasing Material Removal Rate (MRR) through trochoidal strategies (Dynamic Milling). By maintaining low radial engagement (ae <10% D) and high axial engagement (ap up to 2xD), feed rate can be increased and the full cutting-edge length can be used, distributing wear and dissipating heat more effectively.
Which parameters increase efficiency when milling Ti-6Al-4V?
Efficiency parameters:
- Vc: 70-90 m/min (in trochoidal milling one can push higher because the cutter cools while “in air”).
- Table Feed (vf): Very high, compensating for chip thinning.
- Coolant: High pressure or abundant coolant for controlled thermal shock (only in trochoidal roughing where contact time is very short).
Which end mill should be selected to machine Ti-6Al-4V with stability?
Ideal cutter:
- 5-6 Flutes: More teeth = more feed at the same load per tooth. Titanium chips are not excessively bulky, so more flutes can be used.
- Variable Helix: Essential for stability.
- Coating: AlTiN or silicon-based.
How can wear and heat be reduced when machining Ti-6Al-4V?
Wear and heat management:
- Notch Wear: Typical at the depth-of-cut line. Slightly varying ap between passes distributes this wear.
- Monitoring: Check chip color. Straw/blue is acceptable because heat is leaving with the chip. White smoke indicates insufficient coolant.