How can the finish on Grade 5 titanium be improved?

Achieving a mirror-like surface finish (Ra < 0.4 µm) on Grade 5 titanium (Ti-6Al-4V) requires preventing elastic springback and high-frequency vibration. Titanium tends to “grab” the tool; if cutting pressure is not constant, the surface becomes dull and torn. The key is to use finishing cutters with a high flute count (5 or more), high helix angles (45° or more) to maintain continuous contact with the workpiece, and climb milling with the correct finishing allowance (at least 0.1-0.2 mm) so that virgin, non-work-hardened material is cut.

Which end mill should be used to achieve a good surface finish on Grade 5 titanium?

Cutter selection is decisive:

  • Number of Flutes: Use 5, 7, or even 9 flutes. More flutes mean smaller scallop spacing at the same table feed.
  • Helix Angle: A strong helix (45°-50°) reduces initial impact and provides a soft cutting action.
  • Radius: A corner radius not only improves strength but also distributes surface marks better than a sharp corner.

How can tool marks and vibration be reduced when finishing titanium?

Common mistakes to avoid:

  • Dwell: Never stop on the surface. A cutting edge rotating without feed creates chatter marks immediately.
  • Insufficient Finishing Allowance: If only 0.02 mm is left for finishing, the tool rubs rather than cuts, polishing irregularly and leaving marks.
  • Vc: For finishing, Vc can be increased (80-100 m/min) compared with roughing because contact time is short.

Which parameters improve titanium finishing while reducing burrs?

“Zero-burr” parameters:

  • Smooth Exit: Program an arc-shaped roll-out to prevent the edge from tearing the final strip of material.
  • Sharp Edges: Use new cutters for the final pass. A cutting edge with wear > 0.05 mm dramatically increases burr formation on titanium.