
How can hole quality in stainless steel be improved?
La qualità del foro su acciaio inossidabile (cilindricità, rugosità e assenza di bava) dipende dalla stabilità di centraggio e dalla gestione termica. Le punte standard tendono a “vagare” (walk) all’ingresso su superfici inox dure, creando fori leggermente ovalizzati o fuori asse. La soluzione è utilizzare punte in metallo duro con affilatura a 4 facce o geometria autocentrante, precedute da una centrinatura o, meglio ancora, da una punta pilota dello stesso diametro (o leggermente maggiore per l’angolo) se il foro è profondo.
How can clean, burr-free holes be produced in stainless steel?
For H7/H8 tolerances directly from drilling:
- Spindle Run-out: Must be <5 microns. High run-out causes the drill to “ream” the hole and oversize it.
- 3-Flute Drills: For short holes (<3xD), 3-flute drills provide better roundness and surface finish through triple guidance.
- Margins: Double margins burnish the hole wall and improve Ra.
Which drills ensure tight tolerances in stainless steel?
Work hardening: the enemy of stainless steel.
- Do Not Hesitate: Entry and feed must be decisive. Feed that is too low (e.g. < 0.03 mm/rev) causes immediate work hardening at the bottom.
- Pecking: Avoid it. Every time the drill re-enters, it impacts a work-hardened layer. If necessary, reduce the retraction distance and use chip breaking without fully leaving the hole.
How can work hardening be avoided when drilling stainless steel?
Anti-burr exit strategies:
- Discs: 316 stainless tends to form a “cap” at exit that does not detach.
- Technique: Reduce feed by 50% over the last 0.5-1 mm of drilling. This reduces axial thrust that would otherwise push through the material instead of cutting it.